Re-Recording Only Over A Mistake (Auto Punch In/Out) - Boss BR-80 Owner's Manual

Re-Recording Only Over a Mistake
(AUTO PUNCH IN/OUT)
When recording, there may be times when
you made a mistake or were unable to play
as you intended. In such cases, you can use
punch-in/out to re-record only the region
you specify.
While the track plays, you can "punch-in" to
switch from playback to record; then you
can "punch-out" to resume playback, all
without stopping.
Punch-in at the point where you want to
start re-recording, and then punch-out
when you want to stop re-recording.
Playback Recording
Start Punch-In
"Auto punch-in/out" is the operation of
automatically punching-in/out at the
locations you specify beforehand.
* When using auto punch-in/out,
there must be more than 1.0 seconds
between the punch-in and punch-out
points.
MEMO
The data prior to punching-in/out will
remain on the SD card; it will not be
deleted.
To maximize the free space available
on the SD card, you can execute Song
Optimize p. 88) to delete unneeded data.
Playback
Time
Punch-Out Stop
Recording/Playback
1.
Press the [MENU] button .
2.
Use the cursor buttons to move the
cursor to "A . PUNCH," and press the
[ENTER] button .
3.
Use the cursor [
move the cursor to "ON/OFF," and
turn the dial to choose "ON . "
4.
Use the cursor [
move the cursor to "DISP," and turn
the dial to choose the units in which
you'll specify the locations .
Setting Explanation
Specify the locations in units
TIME
of time.
Specify the locations in units
MEASURE
of measures.
] [ ] buttons to
] [ ] buttons to
61