Vacuum Cleaner Connection - Roland EGX-300 User Manual

Part 1

1-8 Vacuum Cleaner Connection

Use a commercially available brush
to remove metal cuttings.
Attempting to use a
vacuum cleaner to take
up metal cuttings may
cause fire in thevacuum
cleaner.
NOTICE
Use a vacuum cleaner that lets you adjust the amount of suction and is equipped with an overload protector.
Always allow a minimum gap of 30 cm (11-13/16 in.) on the side where the vacuum hose exits. The vacuum
hose must have sufficient space in which to move. When the vacuum hose cannot move smoothly, it can cause
malfunctions or errors in operation.
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction opening of the
vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings.
Vacuum up cutting chips and grit during an on-going cutting operation, using the vacuum adapter, and commercial vacuum cleaner.
Before you install the vacuum adapter
1) Switch on the power and press the [ENTER] key. (The head moves inward and to the left.)
2) Press the [ ] key to move the head leftward and toward the front.
3) Switch off the power.
Pass the vacuum hose over
the rail to the rear panel of
the unit.
Tighten
Attach the vacuum
Vacuum
adapter.
adapter
Commercial
vacuum cleaner
26
1
Rail
2
Rear
Leave about 20 cm
(about 8 in.) of open
space behind the unit.
Vacuum duct
32 mm (1-5/16 in.)
3
Secure the vacuum
Tighten
hose in place.
Commercial
vacuum cleaner