Roland EGX-300 User Manual page 27

Setting the Z0 Position
"Z0" is the origin point for the Z axis. This is normally set at a position which corresponds to the surface of the secured workpiece when
mounting the cutter.
1
Press the [MENU] key to make the following screen
appear on the display.
3
Press the [ ] key to move the blinking cursor (" ") to
"Z-Axis," then press the [ENTER] key.
5
Make sure the blinking cursor is on "Y" and press the
[ENTER] key.
2
Press the [ENTER] key to make the following screen
appear on the display.
4
Make sure the blinking cursor is on "Z0" and press
the [ENTER] key.
6
Selecting "Y" displays the following message.
Selecting "N" returns to the coordinate display (the
screen shown in step 1).
Make sure that "< >" appers.
Part 1
25