Loading A Workpiece For Cutting - Roland EGX-300 User Manual

Part 1

1-6 Loading a Workpiece for Cutting

NOTICE
Fasten the tool and material securely in place.
To load workpiece, use the adhesive sheet or clamps included with the machine.
When performing engraving that subjects the workpiece to a load, use the clamps to secure the workpiece in place. When engraving the
edge of the workpiece, use the adhesive sheet.
Large-size material (i.e., material that is about the same size as the EGX-300's table) cannot be affixed to the table securely using the
adhesive sheet or clamps. In such cases, use commercially available double-sided tape to secure the workpiece in place.
A vacuum table (ZV-23A) and a center vise (ZV-23C) are optionally available and should be purchased if needed.
Loading Workpiece Using the Adhesive Sheet
NOTICE
Do not attempt to wash the adhesive sheet with water. Doing so will damage the adhesive surface and make it
impossible to grip the material.
1 Place the adhesive sheet on the table and press it
down.
Adhesive
sheet
Store the adhesive sheet in a location free from dust.
Loading Workpiece Using the Clamps
1
Place the workpiece on the table.
Workpiece
20
2 Place the workpiece to be cut on the adhesive sheet
and fasten it while pressing down.
Workpiece
2
Slide the square portion protruding from the bottom
of the clamp plate into the groove on the table to
secure the workpiece in place.
Wrenches
(10 mm end
of the wrench)
Tighten
Groove
Workpiece
Adhesive
sheet
Clamp