Setting The Z1 And Z2 Position - Roland EGX-300 User Manual

1-11 Setting the Z1 and Z2 Position

The cutter up position (Z2 point) and down position (Z1 point)
are normally set with the software. If they cannot be set with
your current software then set them manually using the keys on
the switch panel.
* The Z0, Z1, and Z2 points can be stored in memory by setting
"Z0/Z1/Z2 MEMORY" to "ON."
1
Press the [MENU] key to make the following screen
appear on the display.
3
Press the [ ] key to move the blinking cursor (" ")
to "Z-Axis," then press the [ENTER] key.
5
Press the arrow keys and the CUTTER UP/DOWN
keys to move the cutter to the height where Z1 (or Z2)
point is to be set.
When setting Z1, move the cutter to a position away
from the loaded workpiece.
Bottom of the head
Z2
Z0
Z1
Cutter up positon Z2
Z0
Cutter down positon Z1
2
Press the [ENTER] key to make the following screen
appear on the display.
4
Press the [ ] key to move the blinking cursor (" ") to
"Z1."
When setting the Z2 point, press the [ ] key to move
the blinking cursor (" ") to "Z2."
6
Make sure the blinking cursor is on "Z1" and press
the [ENTER] key.
Part 1
Cutter
Workpiece
31