Attaching A Vacuum Cleaner - Roland EGX-30 User Manual

Cutting Speed
Turn the SPEED knob on the control panel to
change the cutting speed (tool-movement speed.)
The tool-lowering speed also changes accordingly.
When the values set within the application software or the driver are sent after adjusting the cutting speed on the EGX-30,
the software and driver values are changed.
Conversely, you can also change the cutting speed by rotating the knobs on the EGX-30 after starting a cutting operation
using the software and driver values.

Attaching a Vacuum Cleaner

The dust-collector hose and duct included with the EGX-30 can be attached to an ordinary household vacuum cleaner to remove
cutting chips during operation.
NOTICE
Always allow a minimum gap of 30 cm (12 in.) on the side where the vacuum hose exits. The vacuum hose
must have sufficient space in which to move. When the vacuum hose cannot move smoothly, it can cause
malfunctions or errors in operation.
32 mm (1-5/16 in.)
30 cm (12 in.) or more
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction opening of the
vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings.
22
Vacuum duct
Vacuum
hose
Engraving
Engraving using
a fine engraving
cutter (ZEC-
A2013)
Slower
speed
Faster
speed
Scoring