Explanation Of The Display Menus - Roland EGX-300 User Manual

Part 2

2-3 Explanation of the Display Menus

Go to the submenus for
"I/O".
Go to the submenus for
"OTHERS".
40
This shows the current position of the cutter (in coordinates). The coordinate values
indicate the home position as the origin point on the X and Y axes, and the Z0 point as the
origin point on the Z axis.
It is possible to move from this menu to submenus for setting the X- and Y-axis origin
point (home position), the Z-axis origin point (Z0), the cutter-up position (Z2), the cutter
down position (Z1).
This sets the X- and Y-axis origin point (home position). Use the arrow keys to move the
cutter to the desired location for the home position, and press the [ENTER] key.
For details, see "Setting the Origin (Home Position)".
This sets the Z-axis origin point (Z0), cutter-up position (Z2), and cutter down position
(Z1). Move the blinking cursor (" ") on the display to "Z0," "Z1," or "Z2," align the tip
of the cutter to the height to be set, then press the [ENTER] key.
For details, see "Setting the Z0 Position" or "Setting the Z1 and Z2 Position".
This shows the X/Y-axis feed rate and the Z-axis feed rate.
Move the blinking cursor (" ") on the display to the value for the X-Y axes or for the Z
axis, use the [ ] or [ ] key to set the feed rate, then press the [ENTER] key.
For details, see "Feeding Speed".
"HOME"
This moves the cutter to the current home position (XY origin point).
"VIEW"
This raises the cutter to its highest point and moves the XY table to the front left.
"Z1"
This starts the spindle motor and moves the cutter to the current cutter-down position.
Spindle rotation and cutter changing do not take place while the cover is open.
"Z0"
This moves the cutter to the current Z-axis origin point.
"Z2"
This moves the cutter to the current cutter-up position.
"CLEAR"
This deletes any cutting data stored in the data buffer.
"REPEAT"
This loads cutting data that is stored in the data buffer and performs cutting. This makes
it possible to cut multiple copies of the same shape.
For details, see "Performing Repeat Cutting".
"I/O"
This changes to the menu for the connection interface and setting communication
parameters for serial communication.
"OTHERS"
This changes to the menu for making other settings.