Roland EGX-300 User Manual page 40

Part 2
Changing the Feed Rate or Spindle Speed During Cutting
The feed rate and spindle rotating speed set by the software can be changed while cutting is in progress.
This is done by first pausing the EGX-300 during cutting, then changing the feed rate. However, if the computer subsequently sends a
command to change the feed rate, the setting will change as specified by the new command. When set by software or set directly on the
EGX-300, the setting made last takes precedence.
Spindle speed can be changed at any time. Use the Spindle control to change it.
Changing the Feed Rate
1
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
3
Press the [ ] or [ ] key to move the blinking cursor
(" ") to "XY-SPEED."
To set the lowering speed of the head, move the
blinking cursor (" ") to "Z-SPEED."
5
Press the [ENTER] key.
38
Make sure that
"< >" apears.
2
Press the [MENU] key to make the following screen
appear on the display.
4
Press the [ ] or [ ] key to set the feed rate.
Setting range
X- and Y-axis
Z-axis
: 0.5 to 60 mm/sec
: 0.5 to 30 mm/sec