Initiating A Connection Using The Router In Transparent Pppoe Mode - NetComm NTC-6000 SERIES User Manual

4.1.2 To confirm successful connection
Now click on the link to return to the status page. Please pay close attention to WWAN section on the page. The WWAN status
should be ''up". The Local field shows the current IP address that the network has allocated for the router.
Congratulations. Your new Cellular Router is now ready to use!
4.2 Initiating a connection using the router in transparent
PPPoE mode
To enable PPPoE mode, firstly ensure the "Auto Connect" is disabled in all the profiles on the "Connection" configuration page by clicking
on the "Internet Settings" menu followed by "WWAN (3G)" and then the "Connection" menu item on the right and select each connection
profile and disable the Auto Connection option and save the updated settings..
Select "Enable" to enable PPPoE.
Specify the APN you wish to use to suit your carrier
In addition you may specify an optional "Service Name". When a "Service Name" is specified the connected device must use the same
service name when connecting. This facility is particularly useful if you have more than one PPPoE router or modem on a single Ethernet
network.
Finally click "Save" to save your settings and enable PPPoE.
YML6000
www.netcomm.com.au
NetComm CallDirect™ Series - NTC-6000 Series
NTC-6000 User Guide
23