How To Establish A Connection To The Cellular Network; Initiating A Ppp Connection Directly From The Router - NetComm NTC-6000 SERIES User Manual

How to Establish a Connection to
the Cellular Network
This section describes how to set up the router to initiate a WWAN connection. There are 2 different ways to set up a WWAN connection
via PPP:
Initiating the PPP Connection directly from the router (most common).
Initiating the PPP Connection from a different PPP client (i.e. laptop or router) with the router running in transparent PPPoE mode.
4.1

Initiating a PPP connection directly from the router

The status page of the router should be displayed as below. Please ensure that the SIM Status is 'SIM OK' before you initiate a WWAN
connection.
Click on the "Internet Settings" menu followed by "WWAN (3G)" and then the "Connection" menu item on the right.
4.1.1 To connect using a connection profile
The router supports multiple APN profiles; these profiles allow you to configure the settings that the router will use to connect to the
cellular network.
First examine the list of configured profiles
Select the profile that you wish to connect with and make sure that the APN name field is correct. This is very important
Select "Enable" for the Auto Connect option and click Save
From now on, Auto Connect will remain enabled and the router will automatically connect unless you come back to this page and disable it.
YML6000
www.netcomm.com.au
NetComm CallDirect™ Series - NTC-6000 Series
NTC-6000 User Guide
21