Omron E5CK User Manual page 74

The parameters in this mode can be used only when the "security" parameter (pro-
tect mode) is set to "0" to "2".
This mode contains the auxiliary parameters for adjusting control. These parame-
ters include parameters for limiting the manipulated variable and set point, parame-
ters for switching between remote and local operation, and parameters for setting the
LBA (Loop Break Alarm), alarm hysteresis, and input digital filter values.
To select this mode when in the levels 0 and 1, setup, expansion, option and calibra-
tion modes, press the
menu display. If you select [
1 second minimum, the controller enters the level 2 mode.
To select parameters in this mode, press the
use the or keys.
The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
key for 1 second minimum. The display changes to the
] using the
Parameter Name
Remote/Local
SP ramp time unit
SP ramp set value
LBA detection time
MV at stop
MV at PV error
MV upper limit
MV lower limit
MV change rate limit
Input digital filter
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
Input shift upper limit (temperature)
Input shift lower limit (temperature)
Level 2 Mode
key then press the
key. To change parameter settings,
Page
5-16
5-16
5-16
5-17
5-17
5-17
5-18
5-18
5-18
5-19
5-19
5-19
5-19
5-20
5-20
key for
5--15