Omron E5CK User Manual page 102

Parameter No.
00 PV monitor
86 SP monitor during SP
ramp
04 MV monitor (heat)
42 MV monitor (cool)
01 Set point
02 Alarm value 1
03 Alarm value 2
41 Alarm value 3
19 Proportional band
20 Integral time
21 Derivative time
22 Cooling coefficient
09 Dead band
23 Manual reset value
06 Hysteresis (heat)
43 Hysteresis (cool)
07 Control period (heat)
08 Control period (cool)
44 SP ramp time unit
45 SP ramp set value
46 LBA detection time
47 MV at stop
48 MV at PV error
50 MV upper limit
49 MV lower limit
51 MV change rate limit
56 Input digital filter
25 Alarm 1 hysteresis
26 Alarm 2 hysteresis
52 Alarm 3 hysteresis
53 Input shift upper limit
54 Input shift lower limit
*1 Possible only during reading
*2 During temperature input, the range becomes the range of use of the selected sensor.
*3 During heating and cooling control, the range becomes 0.0 to 105.0.
*4 During heating and cooling control, the range becomes -105.0 to 105.0.
*5 During heating and cooling control, the range becomes -105.0 to MV upper limit -0.1.
About invalid
parameters
Parameter
*1
Scaling lower limit -10% to scaling upper
limit +10%
*1
Set point lower limit to set point upper limit
*1
*1
Set point lower limit to set point upper limit
Currently, if a command is used for invalid parameters (parameters that do not sat-
isfy the conditions of use in Chapter 5), the "undefined" error (end code: IC) is out-
put.
6.4 Commands and Responses
Data Setting and Monitor Range
--5.0 to 105.0
0.0 to 105.0
--1999 to 9999
--1999 to 9999
--1999 to 9999
0.1 to 999.9
0 to 3999
0 to 3999
0.01 to 99.99
--19.99 to 99.99
0.0 to 100.0
0.01 to 99.99
0.01 to 99.99
1 to 99
1 to 99
0: Minutes, 1: Hours
0 to 9999
0 to 9999
--5.0 to 105.0
--5.0 to 105.0
MV lower limit +0.1 to 105.0
--5.0 to MV upper limit --0.1
0.0 to 100.0
0 to 9999
0.01 to 99.99
0.01 to 99.99
0.01 to 99.99
--199.9 to 999.9
--199.9 to 999.9
Mode
*2
Level 0 Level 0
*3
Level 1
*4
*4
*5
Level 2 Level 2
6--7