TANDBERG Codec 3000 MXP Reference Manual page 75

Configuration-type Commands – xconfiguration / configuration.xml
Conference
cont...
Conference AAC-LD-128-Threshold: <384/512/768/1152/1472/1920/2560/3072/4096>
The system will not transmit AAC-LD-128 unless the call rate is equal to or above the specified threshold.
xconfiguration conference aac-ld-128-threshold: 768
Example:
Conference AAC-LD-128-Mono: <On/Off>
If set to Off and the system is transmitting mono, the system will not use AAC-LD-128 even though the call rate is above the AAC-LD-128 Threshold.
xconfiguration conference aac-ld-128-mono: off
Example:
Conference NaturalVideo: <Off/Auto/384/512/768/1152/1472/1920>
Enabling Natural Video will enable 60 (50 on PAL) fields per second true interlaced picture for high motion video. The use of Natural Video requires that H.263+ or H.263++ video
protocols are being used. Natural video will be disabled in H.323 MultiSite calls and in H.320 Continuous Presence MultiSite calls.
When set to Off, Natural Video will be disabled for both transmit and receive.
When set to Auto, the system will enable transmission of Natural Video from 768 kbps and above. Reception of Natural Video is in this case always enabled. However, when set
to Auto the unit will still prioritize the 448p and w448p format over Natural Video. Natural Video can also be configured to be enabled for callrates above a specified threshold
value.
xconfiguration conference naturalvideo: 768
Example:
This will enable NaturalVideo for callrate 768 kbps and above
Conference PictureMode: <4Split/5+1Split/VS/Auto>
Sets the picture layout to be used in a MultiSite conference. If set to Auto the system will change the picture layout depending on the number of participants in the conference.
xconfiguration conference picturemode: auto
Example:
Conference VideoQualityCP: <Motion/Sharpness/Auto>
Sets the video quality to be used in continuous presence mode (4Split/5+1Split).
xconfiguration conference videoqualitycp: sharpness
Example:
Conference FloorToFull: <On/Off>
If PictureMode is set to 5+1Split, and one of the participants in a MultiSite conference is granted floor this setting determines whether to display the participant having floor in full
screen or just in the main window of the 5+1Split.
Example: xconfiguration conference floortofull: on
Conference MaxCallLength: <0..999>
Sets the maximum allowed call length in minutes (0 = Disabled).
xconfiguration conference maxcalllength: 0
Example:
Conference AllowIncomingTlphCall: <On/Off>
If set to Off, the system will not accept incoming telephone calls to an already active conference.
xconfiguration conference allowincomingtlphcall: off
Example:
Conference AllowIncomingMSCall: <On/Off>
If set to Off, the system will not accept incoming calls to an already active multisite conference.
Example: xconfiguration conference allowincomingmscall: off
D 13887.08
MAY 2008
75
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP