Callsetaudiotp; Camerafocus; Cameraforceupgrade; Camerahalt - TANDBERG Codec 3000 MXP Reference Manual

Command Information
CameraFocus — CameraHalt
Command Description

CallSetAudioTP

Command used with
TANDBERG Experia.

CameraFocus

Command used to
change focus of a spe-
cific camera.

CameraForceUpgrade

Command used to
initiate software
upgarde of the
TANDBERG Precision HD
Camera. Should only be
used after downgrade
of the TANDBERG
MXP Codec software
or if the configuration
CameraSwUpgrade is
set to Off. When the
TANDBERG MXP Codec
software is upgraded,
the TANDBERG Precision
HD Camera will be
upgraded automatically
if the configuration
CameraSwUpgrade is
set to Auto.

CameraHalt

Command used to stop
moving a specific
camera.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
Call(r): <1..11>
Mode(r): <On/Off>
Camera(r): <1..13>
Addresses which camera to have its
focus changed.
Value(r): <Auto/Manual/+/->
Specifies the wanted operation.
Camera(r): <1..13>
None
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
None As above
None As above
144
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand callsetaudiotp call:2 mode:on
*r Result (status=OK):
*r/end
OK
xcommand camerafocus camera:1 value:+
*r Result (status=OK):
*r/end
OK
xcommand cameraforceupgrade camera:1
*r Result (status=OK):
*r/end
OK
xcommand camerahalt
*r Result (status=OK):
*r/end
OK
& 6000 MXP