Messageboxdisplay; Piphide; Pipshow; D 13887.08 May - TANDBERG Codec 3000 MXP Reference Manual

Command Information
MessageBoxDisplay — PresetActivate
Command Description

MessageBoxDisplay

Command used to add a
graphical message box
on the screen.

PIPHide

Command used to hide
a PIP on a specific
VirtualMonitor.

PIPShow

Command used to
display a specific picture
in a PIP on a selected
VirtualMonitor

PresetActivate

Command used to
activate a stored preset.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
Title(r): <S: 0, 40>
Message box title.
Line.1..3: <S: 0, 40>
Text to be displayed on the lines
within the box.
Key.1..3: <S: 0, 15>
Text to be displayed on the keys
VirtualMonitor(r): <1..4>
Addresses which VirtualMonitor to
apply the command.
VirtualMonitor(r): <1..4>
Addresses which VirtualMonitor to
apply the command.
Picture(r): <LocalMain/LocalDuo/
RemoteMain/RemoteDuo/
JPEG/TandbergMonitor1/
TandbergMonitor2/None>
Specifies which of the supported
pictures to display in the PIP on the
addressed VirtualMonitor.
Call: <1..11>
If RemoteMain or RemoteDuo is
selected, this parameter must be
supplied to select the correct remote
call.
Position: <BottomLeft/
BottomRight/TopLeft/TopRight>
Specifies where to postion the PIP .
Number(r): <0..14>
The preset to activate.
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
None As above
None As above
160
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand messageboxdisplay title:Welcome
line.1:"How are you?"
key.1:Good
key.2:Bad
*r Result (status=OK):
*r/end
OK
xcommand piphide virtualmonitor:1
*r Result (status=OK):
*r/end
OK
xcommand pipshow virtualmonitor:1 pic-
ture:remoteduo call:5
postion:topright
*r Result (status=OK):
*r/end
OK
xcommand presetactivate number:4
*r Result (status=OK):
*r/end
OK
& 6000 MXP