Startupvideosource; Stillimagesource; Ssh - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
StartupVideoSource — SSH
SNMP SystemContact: <S: 0, 70>
Defines the SNMP system contact.
xconfiguration snmp systemcontact:
Example:
SNMP SystemLocation: <S: 0, 70>
Defines the SNMP system location.
xconfiguration snmp systemlocation:
Example:
SNMP HostIPAddr [1..3]: <IPAddr>
Defines SNMP host addresses.
Example: xconfiguration snmp hostipaddr:
StartupVideoSource: <0/1/2/3/4/5/6>
Defines the video source the system will use as default after a reboot, and after the system goes out from screensaver mode.
If set to 0, the system will use the video source that was selected before reboot.
xconfiguration startupvideosource: 1
Example:
StillImageSource: <0/1/2/3/4/5/6>
Defines the default still image source. If set to 0, the system will use the current main video source as still image source.
xconfiguration stillimagesource: 4
Example:

SSH

Mode: <On/Off>
If set to Off, it will not be possible to connect to the system using SSH. The Command Line Interface can be accessed using SSH (Secure Shell), which allows for secure control
of the TANDBERG MXP .
Example: xconfiguration SSH Mode: On
D 13887.08
MAY 2008
113
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP