Call - TANDBERG Codec 3000 MXP Reference Manual

Status Information – xstatus /xstatus.xml

Call

(status=Disconnected / CallIDLE / Dialing / Alerting / Proceeding / EstablOut / EstablIn / AwaitInCnf / Connected / Disconnecting / Await2ndnr / ClearOut / ClearIn / Syncing / Capex / Synced /
Call [1..10]
NA / Tlph / Vtlph,
type =
NA / ISDN / H320 / H323 / SIP,
protocol =
NA / Incoming /
direction =
1..x
logTag = )
Disconnected
If status =
NA
and type =
NA
and protocol =
NA
and direction =
x
and logtag =
the following will be included:
Cause:
Dialing / Alerting / Proceeding / EstablOut / EstablIn / AwaitInCnf / Connected / Disconnecting / Await2ndnr / ClearOut / ClearIn / Syncing / Capex / Synced / Unframed
If status =
Tlph
and type =
ISDN
and protocol =
Incoming / Outgoing
and direction =
x
and logTag =
the following will be included:
CallRate: 64
RemoteNumber [1..2]:
RemoteSubAddress:
IncomingNumber:
IncomingSubAddress:
Mute: On/Off
Microphone: On/Off
Duration: 0...
MuteOutgoing: On/Off
Incoming / Outgoing):
Channels [1..2] (type =
If type = incoming / outgoing the following will be included:
Rate: 64
Restrict: On/Off
Active / Inactive):
Audio (status =
Status information followed by a
D 13887.08
MAY 2008
Outgoing,
*
will not be shown unless Detailed Level has been set to 2 – see
Appears for incoming calls only
XACLI – Special commands – xpreferences
170
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Unframed,
MXP