Callvideosource; Camera - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
CallVideoSource — Camera [1..13]
CallVideoSource: <0/1/5/6>
The Call Video Source is the default call video source you would prefer to use in a call..
xconfiguration callvideosource: 0
Example:

Camera [1..13]

Brightness
Camera [1..13] Brightness
Camera [1..13] Whitebalance
Camera [1..13] Whitebalance
Camera [1..13] Focus
Camera [1..13] Backlight: <On/Off>
Turns backlight compensation of camera On/Off. Not applicable to TANDBERG WAVE I cameras.
xconfiguration camera 1 backlight: on
Example:
Camera [1..13] DualVisca: <Off/On>
Enables or disables dual visca mode. If enabled, visca control will be available on the RJ11 connector on the camera. If disabled, the RJ11
connector will work as a normal daisy chain port. Applies to TANDBERG Precision HD cameras only.
xconfiguration camera 1 dualvisca: on
Example:
Camera [1..13] Mirror: <Off/On>
Turns mirror mode on/off. Not applicable to TANDBERG WAVE I cameras.
Example: xConfiguration camera 1 mirror: on
D 13887.08
MAY 2008
Mode: <Manual/Auto>
Sets whether to control camera brightness of the different cameras manually or to have it automatically set by the
system.
xconfiguration camera 1 brightness mode: manual
Example:
Level: <0..16>
Defines the brightness level to use if Brightness Mode is set to Manual.
Example: xconfiguration camera 1 brightness level: 10
Mode: <Manual/Auto>
If set to Auto the camera will continuously adjust the whitebalance depending on the camera view.
When set to Manual the whitebalance can be calibrated manually by the command CameraWhiteBalance. The white-
balance of the camera will then remain constant until a new calibration is performed.
xconfiguration camera 1 whitebalance mode: auto
Example:
Level: <0..16>
Specifies the camera whitebalance level. Applies to TANDBERG Precision HD cameras only.
xconfiguration camera 1 whitebalance level: 10
Example:
Mode: <Manual/Auto>
If set to Manual autofocus will never be turned on automatically.
Example: xconfiguration camera 1 focus mode: manual
71
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
If a TANDBERG Video Switch is
connected, the camera ranges
will behave as follows:
•
Camera 1 will be the video
switch.
•
Camera range 2..7 will
be cameras connected to
secondary chain (the chain
originating from Data port 2
of the switch).
•
Camera range 8..13 will be
cameras connected to the
primary chain (the chain
originating from Data port 1
of the switch).
Go to the TANDBERG Video
Switch section to read more.
MXP