Screensaverdeactivate; Screensaverreset; Sitedisconnect; Siteview - TANDBERG Codec 3000 MXP Reference Manual

Command Information
ScreensaverDeactivate — SiteViewEnd
Command Description

ScreensaverDeactivate

Command used to
deactivate screensaver.
NOTE: Warranty will
be void if used with
TANDBERG systems
shipped with Plasma
monitors.

ScreensaverReset

Command used to reset
the screensaver timer.

SiteDisconnect

Command used to
disconnect a specific
site from a MultiSite
conference supporting
H.243.

SiteView

Command used to
requset view of a
specific site in a
MultiSite conference
supporting H.243.

SiteViewEnd

Command used to end
viewing of a specific
site in a MultiSite
conference supporting
H.243. Requires that
the SiteView command
has been issued in
advance.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
None
Delay(r): <1..480>
Specifies the screensaver delay in
minutes.
MCuID(r): <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID(r): <1..191>
The site's terimnal id, referenced to
the MultiSite it is connected to.
MCuID(r): <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID(r): <1..191>
The site's terimnal id, referenced to
the MultiSite it is connected to.
None
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
None As above
None As above
None As above
162
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand screensaverdeactivate
*r Result (status=OK):
*r/end
OK
xcommand screensaverreset delay:90
*r Result (status=OK):
*r/end
OK
xcommand sitedisconnect mcuid:85 termi-
nalid:2
*r Result (status=OK):
*r/end
OK
xcommand siteview mcuid:85 terminalid:2
*r Result (status=OK):
*r/end
OK
xcommand siteviewend
*r Result (status=OK):
*r/end
OK
& 6000 MXP