Set Up A Repeater Unit - NETGEAR DGND3300v2 User Manual

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2
2. Log in to the N300 wireless modem router base unit. Select Advanced > Wireless
Repeating Function to display the Wireless Repeating Function screen.
3. Select the Enable Wireless Repeating Function check box and the Wireless Base
Station radio button.
4. Enter the MAC address for the repeater units.
5. Click Apply to save your changes.

Set Up a Repeater Unit

Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless
connection to the base station.
Note: If you are using the N300 Wireless Dual Band ADSL2+ Modem
Router DGND3300v2 base station with a non-NETGEAR N300
wireless modem router as the repeater, you might need to change
additional configuration settings. In particular, you should disable the
DHCP server function on the wireless repeater AP.

To configure a N300 wireless modem router as a repeater unit:
1. If you are using the same model of N300 wireless modem router for both the base
station and repeaters, you need to change the LAN IP address for each repeater to a
different IP address in the same subnet (see
Note: Failing to change the LAN IP address will cause an IP address
conflict in the network because the factory default LAN IP is the
same for both units.
Use the LAN Setup Options
Advanced Settings (Part 1)
126
on page 110).