Set Up A Client-To-Gateway Vpn Configuration; Step 1: Configure The Client-To-Gateway Vpn Tunnel - NETGEAR DGND3300v2 User Manual

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2
• See Use Manual Policy to Configure VPN Tunnels
and its VPNC defaults are not appropriate for your special circumstances and you have to
specify each phase of the connection. You manually enter all the authentication and key
parameters. You have more control over the process; however, the process is more
complex, and there are more opportunities for errors or configuration mismatches
between your DGND3300v2 and the corresponding VPN endpoint gateway or client
workstation.
Note: NETGEAR publishes additional interoperability scenarios with
various gateway and client software products. Look on the
NETGEAR website at
scenarios.

Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote computer running the NETGEAR ProSafe VPN Client
and a network gateway involves these two steps:
•

Step 1: Configure the Client-to-Gateway VPN Tunnel

the VPN Wizard to configure the VPN tunnel between the remote computer and network
gateway.
• Step 2: Configure the NETGEAR ProSafe VPN Client
the NETGEAR ProSafe VPN Client endpoint.
IP: 192.168.3.1
Figure 3. Client-to-gateway VPN tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
by these VPNC-recommended parameters, see
Circumstances on page 100 for information about how to set up the VPN tunnel.
www.netgear.com
22.23.24.25
Table 2 on page 79. If you have special requirements not covered
Virtual Private Networking
on page 107 when the VPN Wizard
for these interoperability
on page 80 describes how to use
on page 83 shows how to configure
VPN tunnel
Internet
Set Up VPN Tunnels in Special
80
0.0.0.0
Computer running
NETGEAR ProSafe
VPN Client