Step 2: Configure The Netgear Prosafe Vpn Client - NETGEAR DGND3300v2 User Manual

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2
To view or modify the tunnel settings, select its radio button and click Edit.
Note: See Use Auto Policy to Configure VPN Tunnels
information about how to enable the IKE keep-alive capability on an existing
VPN tunnel.

Step 2: Configure the NETGEAR ProSafe VPN Client

This section describes how to configure the NETGEAR ProSafe VPN Client on a remote
computer. These instructions assume that the computer running the client has a dynamically
assigned IP address.
The computer has to have the NETGEAR ProSafe VPN Client program installed that
supports IPSec. Go to the NETGEAR website (http://www.netgear.com) for information about
how to purchase the NETGEAR ProSafe VPN Client.
Note: Before installing the NETGEAR ProSafe VPN Client software, be
sure to turn off any virus protection or firewall software you might be
running on your computer. You might need to insert your Windows
CD to complete the installation.

To configure the VPN client:
1. Install the NETGEAR ProSafe VPN Client on the remote computer, and then reboot.
a. Install the IPSec component. You might have the option to install either the VPN
adapter or the IPSec component or both. The VPN adapter is not necessary.
If you do not have a modem or dial-up adapter installed in your computer, you might
see the warning message stating "The NETGEAR ProSafe VPN Component requires
at least one dial-up adapter be installed." You can disregard this message.
b. Reboot the remote computer.
The ProSafe icon (
c. Double-click the ProSafe icon to open the Security Policy Editor.
2. Add a new connection.
a. Run the NETGEAR ProSafe Security Policy Editor program, and, using the
on page 81, create a VPN connection.
) is in the system tray.
Virtual Private Networking
83
on page 101 for
Table 3