Table of Contents
Advertisement
SAGEM F@st™ 1400 / 1400W
TROUBLESHOOTING
1
Absence of ADSL synchronization
The LINE LED does not come on or is flashing.
• Check that the modem/router is powered up. The PWR LED should be on. If that is not
the case:
- Check that the power pack is properly connected to the mains. If it is connected to a
multiple socket block, check that this is powered up.
- Check that the power pack cable is properly connected to the modem/router.
- Check that the ON/OFF switch (I/0) is in the "I" position.
• Check that the ADSL is properly connected to your telephone socket, to the LINE port of
the modem/router.
• Check that all the ADSL filters are properly connected to each of your telephone sockets.
All your telephone installation sockets must be fitted with an ADSL filter.
If the problem persists, consult your Internet Service Provider.
2
Access to the HTTP configurator is impossible
• Open your usual Web browser.
• In the Address field, type the modem/router's IP address:
Troubleshooting
http://192.168.1.1
30
Advertisement
Table of Contents
