Covers - Sharp SF-2052 Operation Manual

COVERS

TRANSPARENCY COVERS/
INSERTS INSERTS
SORTER
1 2
4 5
8
7
AUDIT CLEAR
0/
C
24
The COVERS mode is used to place covers on the front, back, or
both the front and back of multipage documents.
Front cover sheets can be copied on, but only on the front side
even in the 1-sided to 2-sided and 2-sided to 2-sided copy modes.
The back side of the original designated as the cover will not be
copied.
Back cover sheets cannot be copied on, either on the front side or
on the back side.
Cover sheets must be fed from the manual feed tray and must be
the same size as the copy paper being used to copy the
document.
When the COVERS mode is selected, the stream feeding mode of
the RADF will always be off. See page 8 for the stream feeding
mode.
1 Place the originals face up in the document feeder tray.
Press the COVERS/INSERTS key.
2
If the 1-sided to 1-sided mode was previously selected, the
following message will appear. Otherwise, the message in
step 3 will appear.
USE 10-KEY PAD TO SELECT ORIGINAL TO
COPY MODE. IT IS NOT POSSIBLE TO
CHANGE MODE AFTER THIS FUNCTION IS SET
MARGIN ER
SHIFT
1 /
1 /
ORIGIN
2 /
2 /
Select the desired ORIGINAL TO COPY mode by
3
3
pressing key 1, 2, 3, 4, or 5 on the 10-key pad.
The selected item will be highlighted and then the following
6
message will appear.
9
/ /
/ 1 /
/ 2 / / /
EVEN NUMBER ORIGINALS
ODD NUMBER ORIGINALS
/ 2 / / /
/ 1 / /
/
COVERS AND INSERTS
USE 10-KEY PAD TO SELECT COVERS /
INSERTS MODE.
COVERS INSERTS
: PRESS 1 : PRESS 2
: 1
: 2
: 3
: 4
: 5
COVERS+INSERTS
: PRESS 3