Sharp SF-2052 Operation Manual page 12

USING THE RADF
ODD NUMBER
ORIGINAL TO COPY
2
2
1 1
2
(ORIGINALS)
PRE-COUNT
EVEN NUMBER
ORIGINALS
ODD NUMBER
1 2 3
4 5 6
7 8 9
AUDIT CLEAR
0/
C
(ORIGINALS)
ODD NUMBER
EVEN NUMBER
2
2
ODD NUMBER
1 1
2
PRE-COUNT
ORIGINALS
10
2 If the number of originals is known, use the ORIGINAL
TO COPY key to select EVEN NUMBER or ODD
NUMBER in the ORIGINAL TO COPY section of the
2
1 1
operation panel, then proceed to step 3. If the number
of originals is not known, select PRE-COUNT
ORIGINALS for an automatic count by the RADF and
press the START key.
2
2
1 1
2
THE NUMBER OF ORIGINALS IS --.
START
Enter the desired number of copies.
3
4 Press the START key.
2-sided copies from 2-sided originals
1 Adjust the original guides to the size of the originals
and set the originals face up in the document feeder
tray.
2 Use the ORIGINAL TO COPY key to select
2
2
1 1
2
PRE-COUNT
ORIGINALS
The following message will appear.
When the count is complete and the number is known, replace
the originals in the document feeder tray and select EVEN
NUMBER or ODD NUMBER as above.
If the specified number of copies is more than 50, the copy
quantity display will display 50 after copying starts. If an
optional sorter is installed, the display will change to 20 after
copying starts (in sort mode).
To cancel a copy run during duplex copying, press the clear
( ) key. Incomplete copies will be output from the duplex
tray.
2 .
2