Inserts - Sharp SF-2052 Operation Manual

INSERTS

INSERTS
The INSERTS mode is used to insert
sheets as chapter dividers.
INSERTS
3
6
2
5
1
4
3
2
1
4
3
2
1
INSERTS
3
5
3
2
1
1
3
2
1
6
5
4
3
2
1
1
5
3
1
10
9
8
7
6
5
4
3
3
1
2
1
9
7
5
3
3
1
1
26
Insert sheets can be fed from any of the paper feed stations, but
when the manual feed tray is used for cover stock, insert sheets
must be fed from another tray. If the same paper stock is to be
used for the cover stock and the insert sheets, the manual feed
tray may be used for both.
6
Insert sheets must be the same size as the copy paper being
5
4 used for copying the document.
Up to 18 insert sheets can be inserted into each set of copies.
Insert sheets can be copied on, but only on the front side even in
the 1-sided to 2-sided or 2-sided to 2-sided copy mode. The
6
5
back side of the original for an insert sheet will not be copied.
If the INSERTS mode is selected, the stream feeding mode of
the RADF will always be off. See page 8 for the stream feeding
INSERTS
mode.
6
Some examples of insert sheet placement
5
4
When 1-sided copies are to be made:
6
5
4
INSERTS
When 2-sided copies are to be made:
5
3
INSERTS
9
7
6
4
INSERTS
9
7
5
INSERTS
Insert sheets can be placed with or without printing on them.
See page 27 for inserts with printing.
See page 30 for inserts without printing.
Copying onto insert sheets in this mode is possible only on the
front side.
The chapters of the originals must contain an even number of
pages (a 2-sided original sheet is two pages).
Make uneven chapters of 1-sided originals even by adding
blank original sheets as necessary.
Copies of the opposite sides of a 2-sided original cannot be
separated by an insert sheet.
See page 33 for insert placement with printing.
See page 36 for insert placement without printing.