Table of Contents
Advertisement
COVERS
The COVERS mode is used to place covers on the front, back, or
both the front and back of multipage documents.
Front cover sheets can be copied on, but only on the front side
even in the 1-sided to 2-sided and 2-sided to 2-sided copy modes.
The back side of the original designated as the cover will not be
copied.
Back cover sheets cannot be copied on, either on the front side or
on the back side.
Cover sheets must be fed from the bypass tray and must be the
same size as the copy paper being used to copy the document.
ERASE
1
4
7
0 /
Downloaded from:
http://www.usersmanualguide.com/
<M086>
COVERS INSERTS
3
2
5
6
<M087>
8
9
CLEAR/STOP
AUDIT
C /
CLEAR
I
I
Place the originals face down in the RADF tray.
1
Press the COVERS/INSERTS key.
2
If the 1-sided to 1-sided mode was previously selected, the
following message will appear. Otherwise, the message in
step 3 will appear.
USE 10–KEY PAD TO SELECT ORIGINAL TO
COPY MODE.
IT IS NOT POSSIBLE TO
CHANGE MODE AFTER THIS FUNCTION IS SET.
ORIGINAL TO COPY MODE
1 / / / / / 1
1 / / / / / 2
EVEN NUMBER ORIGINALS
1 / / / / / 2
ODD NUMBER ORIGINALS
2 / / / / / 2
2 / / / / / 1
Select the desired ORIGINAL TO COPY mode by
3
pressing key 1, 2, 3, 4, or 5 on the 10-key pad.
The following message will appear.
USE 10-KEY PAD TO SELECT COVERS/
INSERTS MODE.
COVERS
INSERTS
: PUSH 1
: PUSH 2
PUSH
1
2
3
4
5
COVERS+INSERTS
: PUSH 3
25
Advertisement
Table of Contents
