Power Save Modes - Sharp SF-2052 Operation Manual

Power save modes

The copier has two power save modes – power off timer mode and
preheat mode.
Power off timer mode
The power off timer mode will automatically turn off the power to the
copier after a programmed length of time has elapsed from the time
the power was first turned on.
If the power off timer mode is set, the power will turn off even with
the power switch in the "ON" position. To turn the power back on,
turn the power switch to the "OFF" position, then again to the "ON"
position.
KEY OPERATOR See page 116 for setting the power off timer.
Preheat mode
If the preheat mode is enabled, the copier will enter the mode once
the set time has elapsed without any copier operation after the last
copy of a run is made or power is turned on.
When the copier enters the preheat mode, the message "PREHEAT
MODE. PLACE ORIGINALS IN THE DOCUMENT FEEDER TRAY
OR PRESS ANY KEY ON THE OPERATION PANEL TO RESTORE
THE COPIER TO "READY TO COPY."." will appear.
In this condition, the fuser in the copier is maintained at a lower heat
level thereby saving power. The preheat level is, however, high
enough to allow the copier to come to a ready condition or begin
copying approximately 60 seconds after any key input is made.
To copy from the preheat mode, make desired copier selections
and press the START key using the normal copying procedure.
KEY OPERATOR See page 120 for information on setting the preheat
mode.
POWER ON AND OFF
5