Table of Contents
Advertisement
6
After all originals have been scanned, press the READ-END key.
q
Copying will start.
q
If the memory becomes full of scanned original image data, a warning message will
appear. Press the START ( ) key to start copying the data in memory or the CLEAR
ALL (CA) key to cancel copying.
q
The memory can be extended to a maximum of 272 MB to increase the capacity for
storing image data by adding commercially available memory modules. Please contact
your service centre for details.
Offset stack
If the offset stack mode is enabled using a key operator program, each copy set will be offset by
approximately 25 mm (1 inch) from the previous set. When copying in the sort mode, collated sets of
copies will be made and each collated set of copies produced will be stacked offset from the previous
set in the centre tray. When copying in the group mode, groups of multiple copies from the same
original will be made and each group produced will be stacked offset from the previous group in the
centre tray.
If the offset stack mode is disabled, copies will not be offset.
The offset stack mode is enabled in the factory default setting.
5KEY OPERATOR See page 130 for the offset function.
SORT/GROUP
4
59
Advertisement
Table of Contents
