Table of Contents
Advertisement
Account control
The programs of this category are used to set the internal auditor functions. These programs can be
selected by using the
highlighting the desired program, and then pressing the OK key.
Auditing Mode
This program is used to enable or disable the basic auditing mode.
When enabled, the message in the display will be "Enter your account number." Copying in this state is
limited to operators with an assigned 5-digit account number.
When disabled, the message in the display will be "Ready to copy." Access to copying is open to any
operator.
A maximum of 50, 5-digit account numbers can be assigned. Use key operator program "Account
Number Control" (page 138) to assign account numbers.
To enable the auditing mode, highlight "AUDITING MODE" and press the
OK key to display a check mark in the check box.
To disable the auditing mode, select this program and press the OK key
again to clear the check mark in the check box.
Copies per Account
This program is used to display the total number of copies made against each account number.
An A3 or 11" x 17" copy is counted as two copies. A two-sided copy is also counted as two copies.
When "COPIES/ACCOUNT" is selected and the OK key is pressed, the following display will appear.
1.
Press the
G
The number of copies made will be displayed.
G
Account data is displayed in ascending order of account number.
2.
Press the OK key.
and
keys to highlight "ACCOUNT CONTROL", pressing the OK key,
COPIES/ACCOUNT
ACCOUNT #:18114
COPIES
-----
key to advance through the accounts.
KEY OPERATOR PROGRAMS
003,456
8
137
Advertisement
Table of Contents
