Table of Contents
Advertisement
KEY OPERATOR PROGRAMS
Function setting
The programs of this category are used to adjust various settings of copier functions. These programs
can be selected by using the
highlighting the desired program, and then pressing the OK key.
Key Operator Number Change
See page 120, REGISTERING THE KEY OPERATOR CODE NUMBER.
Exposure Adjust
Use this program to lighten or darken copies in the automatic exposure mode. The exposure level can
be set for copying from the platen glass or copying from either an optional SPF or RSPF. The factory
setting is level 3.
When "EXPOSURE ADJUST" is selected and the OK key is pressed, the following display will appear.
1.
Use the
RSPF".
2.
Adjust the exposure using the
3.
Repeat steps 1 and 2 to adjust the other exposure level.
4.
Press the OK key.
Margin Default
Set the initial margin shift value with this program.
When "MARGIN DEFAULT" is selected and the OK key is pressed, the following display will appear.
G
This program can be used only if an optional dual function board is installed.
MARGIN DEFAULT
1
4 mm
/
(5~20)
1.
Adjust the initial margin shift value using the
G
The value can be set from 5 mm to 20 mm in 5 mm increments (from 1/4" to 1" in 1/4"
increments).
2.
Press the OK key.
128
and
keys to highlight "FUNCTION SETTING", pressing the OK key,
EXPOSURE ADJUST
PLATEN
SPF/RSPF
and
keys to select the "PLATEN" (platen glass) or "SPF/
and
keys.
MARGIN DEFAULT
1
4 inch
/
(1/4~1)
and
keys.
Advertisement
Table of Contents
