Various settings
To change the software SW
1
Log on to the administrator mode, and then touch [Admin. 2].
–
For details on displaying the Administrator Management 2 screen,
refer to "Administrator settings" on page 11-18.
The Initial Settings screen appears.
2
Touch [Software SW].
3
Touch [Mode Selection], and then
use the keypad to type in the mode
number.
4
Touch either [Bit Selection] or [HEX
Selection], and then specify the
setting.
–
To specify Bit selection, touch
[Bit Selection], touch
move the cursor to the bit to be
changed, type in the value using
keypad, and then touch [Set] on
the lower right of the screen.
bizhub 350/250 (Phase 2.5)
or
to
11
11-25