Technics SX-KN2400 Operating Instructions Manual page 94

13_Part VIII.fm 149 ページ ２００３年２月５日 水曜日 午後１時５１分
Part VIII
<PAGE 4>
FILTER RESONANCE:
∧
Use the RESO and
amount of resonance (0 to 127).
ATTACK TIME:
∧
Use the ATT and
attack time (0 to 127).
DECAY TIME:
∧
Use the DEC and
decay time (0 to 127).
RELEASE TIME:
∧
Use the REL and
release time (0 to 127).
BRIGHTNESS:
∧ ∨
Use the BRI and
ness of the sound (0 to 127).
<PAGE 5>
MONO/POLY MODE:
Use the MONO/POLY
the output mode.
PORTAMENTO:
Use the PORTAMENTO ON/OFF buttons to
enable or disable the portamento function. (Por-
tamento is a continuous gliding movement from
one tone to another.)
∧ ∨
Use the and buttons to specify the porta-
mento time.
• PORTAMENTO does not function for the
POLY MODE.
∨
buttons to adjust the
∨
buttons to specify the
∨
buttons to specify the
∨
buttons to specify the
buttons to adjust the bright-
∧ ∨
and buttons to select
VIBRATO RATE:
∧ ∨
Use the RATE and buttons to specify the
vibrato speed (0 to 127).
VIBRATO DEPTH:
∧ ∨
Use the DEP and buttons to specify the
vibrato depth (0 to 127).
VIBRATO DELAY:
∧ ∨
Use the DEL and buttons to specify the time
interval from when the keys are played until the
vibrato starts (0 to 127).
• The center value is 64 (±0).
MODULATION SENSITIVITY:
∧
Use the MOD SENS and
the sensitivity of the MODULATION.
∧ ∨
• Use the MSB and buttons (half-tone incre-
∧
ments) and the LSB and
the setting.
BEND RANGE:
∧
Use the BEND RANGE and
ify the PITCH BEND range (0 to 12). Increments
are in semi-tones.
• The higher the number, the greater the
change in pitch when the PITCH BEND wheel
is operated.
Sound
∨
buttons to adjust
∨
buttons to adjust
∨
buttons to spec-
149
QQTG0692