Technics SX-KN2400 Operating Instructions Manual page 58

10_Part V.fm 113 ページ ２００３年１月２７日 月曜日 午後１時４５分
Part V
MEASURE COPY
Copy recorded data of specified measures to a
specified point.
• On the destination track, the new data
replaces the current measure contents.
1.
Specify the measures you wish to copy from
the source track (FROM).
• On the FROM side, specify the settings with
the corresponding buttons.
PART:
Select the part to copy from. (If ALL is
selected, all parts are copied.)
FIRST MEASURE:
Specify the first measure to copy.
LAST MEASURE:
Specify the last measure to copy.
MEASURE ERASE
Erase the recorded contents of specific mea-
sures.
• Note that only the contents of the measures
are erased, not the measures themselves; the
length of the performance remains the same.
∧
1.
Use the PART and
part.
• If ALL is selected, data is erased from the
specified measures of all the parts at one time.
2.
Use the FIRST MEASURE
specify the start point (measure number).
∨
buttons to specify the
∧ ∨
and buttons to
2.
Specify where you wish to copy the selected
measures to.
• On the TO side, specify the settings with the
corresponding buttons.
PART:
Select the part to copy to.
START MEASURE:
Specify the start point to copy the selected
measures to.
3.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
• If the FROM and TO parts are the same and
the FROM and TO measures overlap, copy is
not possible.
3.
Use the LAST MEASURE
specify the end point (measure number).
4.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
Composer
∧ ∨
and buttons to
113
QQTG0692