Technics SX-KN2400 Operating Instructions Manual page 152

09_Part IV.fm 101 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV
Changing the note position etc. of the
recorded data
You can change the note pitch and position etc. of recorded data.
Select the function
1.
On the SEQ MENU display, use the SONG
∨
and buttons to select the number of the
song. Then select RANGE EDIT.
• The display looks similar to the following.
2.
On the RANGE EDIT display, select a func-
tion.
3.
Perform the editing procedures. (See below.)
• During the editing procedure, if the indicator
for the TEMPO/PROGRAM is lit, you can use
the TEMPO/PROGRAM for the editing func-
tion.
NOTE CHANGE
∧
Change of pitch of specified notes.
1.
Use the TRACK
track you wish to edit.
• You cannot select the track for the CONTROL,
RHYTHM or CHORD part.
• If ALL is selected, all tracks will be edited.
2.
Use the FIRST MEAS
specify the start point (measure number) of
the note change.
3.
Use the LAST MEAS
ify the end point (measure number) of the note
change.
4.
Use the TARGET NOTE
specify the pitch of the note you wish to
change.
• The number next to the note name is its note
number.
5.
Use the CHANGE TO
specify the pitch you wish to change to.
6.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
Sequencer
∧ ∨
and buttons to select the
∧ ∨
and buttons to
∧ ∨
and buttons to spec-
∧ ∨
and buttons to
∧ ∨
and buttons to
101
QQTG0692