Drum Edit - Technics SX-KN2400 Operating Instructions Manual

09_Part IV.fm 95 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV
CYCLE PLAY
You can aurally check the data you are editing by
accessing the CYCLE PLAY display from the
NOTE EDIT display.
• If you wish other tracks to be played back,
they should be selected beforehand on the
SEQUENCER PLAY display. (Refer to page
81.)
1.
On the NOTE EDIT display, press the PLAY
button.
• The display looks similar to the following.
2.
Use the START MEASURE
to select the beginning playback measure.
3.
Use the END MEASURE
select the last playback measure.

Drum Edit

The DRUMS part can be edited on a specialized display. This differs from the normal STEP RECORD edit
procedure, and is a convenient way to check the data for each note.
1.
On the SEQ MENU display, select RECORD
& EDIT.
2.
On the RECORD & EDIT display, select
DRUM EDIT.
3.
On the PART SELECT display, select the
track for the DRUMS part.
• The CHORD, RHYTHM and CONTROL tracks
cannot be selected.
• The display looks similar to the following.
4.
• Cycle playback of the specified measures
• If the SOLO button is turned on, playback
5.
• During playback stop, if the SEQUENCER
∧ ∨
and buttons
∧ ∨
and buttons to
4.
• The number to the left of the instrument name
• If sounds other than percussion instrument
5.
6.
• Recorded performance data is shown as verti-
• You can use the INC
• Use the POS L and M buttons to change the
Press the START/STOP button.
begins.
changes to that of the recording track only. If it
is turned off, all the tracks specified on the
SEQUENCER PLAY display are played back.
To stop cycle playback, press the START/
STOP button again.
RESET (FILL IN 1) button is pressed, the
SEQUENCER returns to the measure number
specified in step 2. If the SEQUENCER
RESET button is pressed
SEQUENCER returns to measure 1.
∧ ∨
Use the SOUND and buttons to select the
percussion instrument you wish to edit.
is its MIDI NOTE NUMBER in the Technics
arrangement.
sounds are assigned, they are not displayed.
Use the MEAS L and M buttons to select the
measure you wish to edit.
Use the CURSOR and
the cursor (M) to the point you wish to edit.
cal bars. Data selected for editing is high-
lighted.
∧
change the increment of cursor movement.
The resolution can be set at
NOTE data is present between increments,
the cursor will stop.
value.
(Continued on the next page)
Sequencer
again, the
buttons to move
∨
and buttons to
/96. However, if
q
95
QQTG0692