Chorus; Conductor - Technics SX-KN2400 Operating Instructions Manual

06_Part I.fm 42 ページ ２００３年２月５日 水曜日 午後２時３８分
Part I
MULTI EFFECT
The MULTI EFFECT works like a studio effects
processor, providing effects such as CHORUS,
PHASER, DELAY and DISTORTION.
1.
In the CONDUCTOR or PART SELECT sec-
tion, turn on the part to which this effect will be
applied.
2.
Press the MULTI EFFECT button to turn it on.
Type and parameter settings
1.
Press and hold the MULTI EFFECT button for
a few seconds.
• The display changes to the following.
Use the L and M buttons to select an effect
2.
group.
• The EFFECT MEMORY is for edited effects
(see below).
3.
Use the buttons to the right of the display to
select the type.
• If the types comprise more than one display
"page," use the PAGE buttons to switch
pages.
• Press the VARI button to enable the variation
effect.
• This display can also be accessed from the
REVERB & EFFECT MENU display. (Refer to
page 155.)
42
QQTG0692
MULTI
EFFECT
EFFECT EDIT
The effects can be edited and then stored in a
memory.
1.
Select an effect type to use as a base.
2.
Press the EDIT button.
• The display changes to the following.
Use the PARAMETER L and M buttons to
3.
select the parameter.
∧ ∨
4.
Use the VALUE and
setting.
• The parameters vary depending on the effect
type selected as the base.
• (V) is the abbreviation of VARIATION.
5.
Press the WRITE button.
6.
Press the EFFECT NAMING button and
assign a name to the effect, if necessary.
• Refer to page 65 for details about the
NAMING procedure.
Use the EFFECT MEMORY L and M buttons
7.
to specify the location in which to store the
edited effect.
8.
Press the OK button.
Sounds and effects
buttons to adjust the