Technics SX-KN2400 Operating Instructions Manual page 39

19_Initialize.fm 189 ページ ２００３年１月２７日 月曜日 午後１時５６分
Symptoms which appear to be signs of
trouble
The following changes in performance may occur in the Technics Keyboard but do not indicate trouble.
Phenomenon
The buttons, keys, etc. malfunction.
No sound is produced when the keys are
pressed.
Only percussive instrument sounds are produced
when the keyboard is played.
The volume is very low when the keyboard is
played.
The sound you hear is different from the sound
you selected.
The rhythm does not start.
No sound is produced for the automatic accom-
paniment, or only the sounds of some parts are
produced.
Storage is not possible.
The playback measure indication is different from
when the performance was recorded.
Remedy
• Turn off the POWER button once, then turn it on again.
If this procedure is not successful, turn off the POWER
button once. Then, while pressing the three lower left
buttons in the RHYTHM GROUP section (JAZZ &
SWING, BALLROOM & SHOW and LATIN &
WORLD) at the same time, turn the POWER button on
again. (Note that, in this case, all programmable set-
tings, functions and memories return to their factory-
preset status.)
• The MAIN VOLUME is at the minimum setting. Adjust
the volume with the MAIN VOLUME control.
• The volumes for the selected parts are set to the mini-
mum levels. Use the balance buttons to set the vol-
umes of the relevant parts to appropriate levels. (Refer
to page 29.)
• The part is muted. (Refer to page 30.)
• The LOCAL CONTROL for a part performed on the
keyboard is set to OFF. Set the LOCAL CONTROL to
ON. (Refer to page 180.)
• In the SOUND GROUP section, the DRUM KITS but-
ton is on.
• The volume setting in the SEQUENCER contents is
very low. Follow the INITIAL procedure to reset the
settings. (Refer to page 186.)
• This sometimes occurs
SEQUENCER or COMPOSER data which was cre-
ated on a different model, or when MIDI data is
received from a connected instrument. Select the
desired sounds again.
• The DRUMS volume is set to the minimum level. Use
the balance buttons to set the DRUMS volume to an
appropriate level.
• A SEQUENCER PLAY button is on. When you are not
playing back the SEQUENCER performance, turn off
the SEQUENCER PLAY button.
• CLOCK is set to MIDI. Set CLOCK to INTERNAL.
(Refer to page 181.)
• An ACCOMP part does not sound if its corresponding
volume is set to the minimum level. Use the respective
balance buttons to set the ACCOMP 1–5 volumes to
appropriate levels.
• The remaining memory capacity of the SEQUENCER
is 0. Follow the SONG CLEAR or TRACK CLEAR pro-
cedure to erase the memory. (Refer to page 93.)
• The number of measures corresponds to the time sig-
nature of the rhythm selected at the start of recording.
To change the rhythm in the middle of the song, record
the rhythm change in the RHYTHM part. (Refer to
page 90.)
when you play back
189
QQTG0692