Technics SX-KN2400 Operating Instructions Manual page 92

13_Part VIII.fm 147 ページ ２００３年２月５日 水曜日 午後１時５１分
Part VIII
Part Setting
Set the various sound attributes for each part.
Selecting an attribute
1.
On the SOUND MENU display, select PART
SETTING.
2.
Use the PART SELECT
select the part.
<PAGE 1>
SOUND:
∧
Use the SOUND
sound.
• The buttons on the control panel may also be
used to select a sound.
VOLUME:
∧
Use the VOL and
ume (0 to 127).
PAN:
∧
Use the PAN and
reo balance (L64–CENTER(CTR)–R63).
• At L64, the sound is completely to the left, at
R63 completely to the right. At CENTER, the
sound is at the center. The display indicates
the selected position.
• Even at the same numerical value, the stereo
balance may differ slightly depending on the
sound.
SUSTAIN:
Use the SUSTAIN ON/OFF buttons to enable or
disable the SUSTAIN function.
∧ ∨
Use the and buttons to adjust the length of
the sustain.
∧ ∨
and buttons to
∨
and buttons to select a
∨
buttons to adjust the vol-
∨
buttons to adjust the ste-
3.
Use the buttons below the display to adjust
each attribute (explained in detail following).
• The settings display is comprised of 5 pages.
Use the PAGE buttons to switch pages.
• When you have completed adjustment of an
attribute, use the buttons along the bottom of
the display to select the next attribute you wish
to adjust.
4.
When you have completed adjusting all of the
settings for one part, select another part and
repeat the adjustment procedure as desired.
• The settings and effects of the PAN, EFFECT
etc. may differ depending on the sound.
KEY SHIFT:
∧ ∨
Use the KEY and buttons to specify the
amount of key shift (−24 to +24).
• A value of 1 means a shift of one semi-tone.
To raise (or lower) the pitch one octave, set
the value to +12 (or −12).
∨
• The button is used to lower the pitch, and
∧
the button to raise the pitch.
TUNING:
∧ ∨
Use the TUNE and buttons to adjust the fine
tuning (−128 to +127).
∨
• The button is used to lower the pitch, and
∧
the button to raise the pitch.
Sound
147
QQTG0692