Technics SX-KN2400 Operating Instructions Manual page 143

09_Part IV.fm 92 ページ ２００３年２月５日 水曜日 午後１時３４分
Part IV
Quantize
The QUANTIZE function can correct the timing of your performance after it has been recorded. If the
rhythm is slightly out of sync or inexact, it will automatically be corrected to the specified quantize level.
1.
On the SEQ MENU display, select RECORD
& EDIT.
2.
On the RECORD & EDIT display, select
QUANTIZE.
• The display looks similar to the following.
Rhythm as written
in the score
Timing of actual
performance
Quantized
performance
∧
3.
Use the TRACK
the track number.
• You cannot select the track for the CONTROL,
RHYTHM or CHORD part.
• If ALL is selected, all the tracks are quantized.
4.
Use the FIRST MEAS
specify the start point (measure number).
5.
Use the LAST MEAS
ify the end point (measure number).
∧
6.
Use the VALUE
quantize level.
• Select from , ,
3
q e e
triplet-type note.)
92
QQTG0692
∨
and buttons to specify
∧ ∨
and buttons to
∧ ∨
and buttons to spec-
∨
and buttons to specify the
, , , , . (A 3 denotes a
3 3
x x r r
∧
7.
Use the STRENGTH and
the amount of quantize (%).
• 100% is a convenient setting. When set to
100%, the performance data is quantized
exactly to the level specified for the VALUE
("just"). For example, at 50%, the data is quan-
tized to a point that is half that of the just level.
By this setting, you can attain an effect that is
very slightly off-beat from the rhythm.
∧
8.
Use the WINDOW and
the range (%) affected by the quantize setting.
• With the increment set to 100 for the VALUE,
at a + setting, data close to the just point is
corrected, and at a – setting, data far from the
just point is corrected. For example, if set to
–30% the quantize function affects data far
from the just point, and if set to +30% the
quantize function affects data close to the just
point. +100% is usually a convenient setting.
• The +100% setting and the –100% setting are
the same.
Example: When VALUE is set to
100% 50% just
+100%
+50%
+30%
–50%
–30%
–100%
9.
Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
Sequencer
∨
buttons to select
∨
buttons to specify
q
e
50% 100%