Technics SX-KN2400 Operating Instructions Manual page 20

15_Part X.fm 170 ページ ２００３年２月５日 水曜日 午後１時５５分
Part X
3.
Use the buttons below the display to assign a
name.
• Set the character input position with the POSI-
TION buttons, select the characters with the
alphanumeric buttons
assignment.
• Switch from upper to lower case letters with
the ABC, abc button.
• Press the INS button to enter a space at the
cursor position.
• Press the DEL button to erase the character at
the cursor position.
• Press the CLR button to erase the entire
name.
• Press the →← button to center the name.
4.
When you have finished typing the name,
press the OK button.
• The display returns to the MEMORY WRITE
display.
∧ ∨
5.
Use the and
ORY number in which to store the new sound
(1–40).
6.
Press the OK button.
• The new sound is stored, and "COMPLETED!"
is shown on the display.
• The SOUND EDIT mode is turned off.
• The stored sound memories can be saved on
a disk/an SD card for recall at a later time.
(Refer to pages 125, 140.)
170
QQTG0692
and repeat name
buttons to select the MEM-
Select a new sound
You can select your original sound just like the
other sounds in the SOUND GROUP.
1.
In the SOUND GROUP section, press the
MEMORY button.
MEMORY
• The list of sounds is shown on the display.
2.
Select the desired sound from the list on the
display.
Sound Edit