KitchenAid KUDS01FLSS7 Installation Instructions Manual page 18

Bottom sound pad installation (on somemodeHs)
1. Remove the bottom sound pad from inside the
dishwasher and take it out of the pHasfic bag.
2. Hace pad on the floor in front of the dishwasher,
making sure Hettedng is facing up and vinyH pad faces
down.
3. Foil up and hoH the side paneHs down. Carefully slide
the pad toward the back of the dishwasher as far as it
vvHH go, making sure not to push or pull any wires or
hoses. (Do not force.) Side paneHs wHH open to proper
position.
NOTE: If there are pipes or other obstructions coming
up through the floor, you will need to cut a slit in the
pad to fit around the obstacle.
..... i i!!i!iiiiiiiiiiiiiii ii i ii ii iiiiiiii !i!i!ii!!i
4. Fold the front end of the pad up into position. Make
sure the vinyl pad is tucked up behind the door and the
dishwasher front legs, as shown.
Complete installation
1. Check that grounding clip is attached to the lower
panel.
2. Place the lower panel behind the access panel. Some
models have insulation on the access panel which must
fall behind the insulation on the lower panel.
grounding
clip
3. Hold the two panels together and place them against
dishwasher leg.
4. Reinstall the screws through the holes in the access
panel and the slots in the lower panel. Install right side
screw first.
/
/
/
5. Check that the lower edge of the lower pane[ contacts
the floor.
6. Tighten the screws.
Direct wire method:
Emectricat Shock Hazard
EBectricaHy ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or emectricamshock.
Power supply cord method:
Emectrical Shock Hazard
Plug into a grounded 3 prong outmet,
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord,
Failure to follow these instructions can result in death,
fire, or emectrical shock.
7. Reconnect power or plug in dishwasher_
18