Advertisement
Available languages
Available languages
JnstaR
the
door
handle
{on some modeHs)
IMPORTANT: Do not scratch the front paneH during this
procedure,
1. Remove the Architect
TM
Series handHe, pHasfic washers
and two screws from handHe package,
2. Attach the handHe to the factory-suppHied
full front paneH
as shown,
film that is JfJ'--
not to be
removed
Pro Line "_Series
1. Remove the Pro Line
TM
Series handHe and two screws
from handHe package,
2. Make sure phsfic
spacers are sfiU attached to the door,
3. Attach the handHe to the factory-suppHied
full front paneH
as shown,
Install
door
panel
{on some models)
Top vented
models
NOTE:
Features
on your
dishwasher
may
differ
from
model
shown.
vent
Option
1:
ForTop
vented
models
with
a factory-supplied
stainless
or
painted
full
front
panel:
1. Remove
the carton
containing
the factory-supplied
full
front
panel.
2. Remove
the handle
package
from
the front
of the
shipping
base.
3. Remove
the inner
panel
from
the door.
4. With
aTORX
_ screwdriver,
remove
three
screws
from
both
sides
of the door.
Hold
the inner
panel
up while
removing
the screws.
5. Gently set panel aside,
NOTE: Some models have 4 screws per side.
screws
screws
door
panel
do not remove screw.
6. Lay the factory-supplied
full
front
panel
face down
on a
protective
non-scratching
surface.
7. Place the inner
panel
on the back of the full front
panel
as shown
and attach,
using
the four #10-16
x 3/8" screws
in the literature
package.
4 screws
?
/
full front panel
inner door panel
_
top of panel
8. Attacl_ tl_e factory-supplied
full front panel, inner panel,
and handle assembly
to the door,
9. Reinstall the two uppermost
screws into the inner panel,
do not tighten
completely,
This will hold the full front
panel in place on the door frame,
2 screws ,
10. hstall
the two #8-18
x 1-3/8"
screws
from
the literature
package
in the top corners
of the door.
11. Align
the top edge
of the full front
panel
with
the top
edge
of the console
and secure
corner
screws.
12. Tighten
the two
screws
installed
in Step
9.
13. Reinstall
and tighten
the remaining
screws
in the inner
panel.
2 screws
i
align top edges
11
Advertisement
