Manual Bypass Copying - Minolta EP3050 Operator's Manual

6. Manual Bypass Copying

Use the Manual Bypass to make copies on paper not loaded in any Drawer, or to copy onto
transparencies, translucent paper, or any other special paper.
You can also use the Cover mode when the Multi Bypass Table is used with the
Automatic/Duplexing Document Feeder AF-3/AFR-9 (option).
Copy Paper That Can be Used for Manual Bypass
Types of Paper
Plain paper (weighing 60 to 90 g/m
Heavyweight paper (weighing 90 to 157 g/m
Transparencies, translucent paper
Paper Size
Width: 100 to 297 mm
Length: 140 to 432 mm
Capacity
Plain paper (white) ... 50 sheets or less
Plain paper (once-copied paper) ... 20 sheets or less
Heavyweight paper, transparencies, translucent paper ... 20 sheets
Using the Manual Bypass
Place the original on the Original
1
Glass and make the control panel
settings.
NOTE
The following functions cannot be
selected for Manual Bypass:
Auto Paper, Auto Size, Finishing,
2-Sided Copying,
Margin-by-Reduction, Erase,
1[2in1] 1 and 2[2in1]
Swing down the Multi Bypass Table
2
and slide the Paper Guide Plate to the
size of the copy paper.
2
)
2
)
3
1.
1136O079AA
p. 81
Place a neat stack of copy paper on the
Table and insert it into the copier until
it stops.
NOTES
Before inserting, fan the paper stack
well if you are using transparencies or
translucent paper.
Correct any curl if you are using
heavyweight paper.
When using once-copied paper, load
the paper stack so that the blank side
faces up.
39
1136O080AA