Table of Contents
Advertisement
User Mode Settings
6.9
User Set – 3/6
1
Touch the User Mode box on the Control Panel.
The display will change.
Touch the [User's Choice] box on the Touch Panel.
2
The display will change.
Touch the Tab [3/6].
3
Setting the Auto Panel Reset
Set the amount of time that should elapse after the last copy process or
user input on the copier before the copier automatically returns to its
Default Settings.
Touch the box with the desired time.
Ü
or
Touch the [No Reset] box to prevent the copier from returning to its
Default Settings automatically.
The default setting is "1 Minute".
Setting the Energy Saver Mode
Set the amount of time that should elapse after the last copy process or
user input on the copier before the copier automatically returns to Energy
Saver Mode.
If the copier is only in intermittent use, use the Energy Saver Mode during
the copier's idle time. This lowers the copier's energy consumption and
only requires a 30-second warm-up phase.
Touch the [Cancel] box and enter a value in minutes from 1 to 120
Ü
using the 10-Key Pad.
The default setting is "15 Minutes".
Setting the Drum Dehumidifier
Specify whether the "Drum Dehumidifier" should be run automatically
when the copier is switched on.
Touch the [On] box to perform the Drum Dehumidifier operation when
Ü
the copier is switched on.
The default setting is "Off".
Rev. /
6
6-9
Advertisement
Table of Contents
