Changing The Presser Foot; Presser Foot Pressure (A); Presser Foot Lever (B); Sensor Buttonhole Foot - Husqvarna Viking Platinum 995E User Manual

Learn your Platinum

Sensor Buttonhole Foot

When connected to the machine it gives
a buttonhole length tting the button size
that has been entered into the machine. The
middle mark gives a 9/16'' (15 mm) button-
ing edge.
Read more about different optional presser feet in
the Accessory User's Guide.

Changing the Presser Foot

Switch off the main switch.
1. Make sure that the needle is in the
highest position. Pull the presser foot
towards you.
2. Line up the cross pin on the foot with
the gap in the presser foot ankle.
3. Press back until the foot snaps into
place.

Presser Foot Pressure (a)

The presser foot pressure is adjusted with
the dial found under the lid on your Plati-
num. Normal setting is around four. The
higher the number the more pressure the
foot puts on the fabric. Knit and soft fab-
rics should be sewn at lower pressure.

Presser Foot Lever (b)

The presser foot is raised and lowered with
the presser foot lever. The presser foot
must be lowered when sewing.
By raising the presser foot lever and then
press it upwards, the lift height of the
presser foot is raised to extra height to slide
very thick projects under the foot.
14
1.
a
2.
3.
b