Husqvarna Viking Platinum 995E User Manual page 56

Embroidery
Lettering Combinations
Font Embroidery d-Card Clarendon font
100:2 is included with your Platinum 955E.
When embroidering more than one letter/
character, the start point always follows the
end point of the previously embroidered
letter/character.
If the rst letter/character is rotated and/
or scaled, the next will be adjusted accord-
ing to the same settings.
To embroider the word "Platinum", attach
the embroidery unit and slide in the Claren-
don font d-Card.
After calibration, the text "
twice on the InfoDisplay. Touch the
button to step between the available sizes.
• Select size 20 mm.
The font d-Card has three menus, upper
case letters (A..), lower case letters (a..)
and numbers/special characters (1..). Step
between the menus by touching the
button.
• Select upper case letters. A.. is visible in
the Overview Window.
• Touch stitch selection buttons 1 and 6 to
select "P".
• To t the entire word into the hoop,
touch the
ROTATION
• Touch
POSITIONING ARROW UP
the starting position to the top of the
embroidery area.
/
• Touch
START STOP
When "P" is completed, touch
select lower case letters (a..).
• Touch stitch selection buttons 1 and 2 to
select "l".
/
• Touch
START STOP
Your Platinum 955E automatically rotates
and positions the letter "l" next to the
already embroidered "P".
54
" ashes
SIZE
MENU
button once.
to move
to start embroidering.
to
MENU
to start embroidering.
Continue selecting and embroidering the
letters a, t, i, n, u, and m according to above
instructions until the whole word is embroi-
dered.
When positioning the characters close to an
edge of the embroidery hoop, make sure to
have enough space, considering both height
and width, for the characters you wish to
embroider.
If a character is too high and/or wide to t
next to the previously embroidered one, the
hoop is moved back to the center of the
embroidery area. You can choose to move
the character to the best position possible
or to rehoop the fabric to avoid misplace-
ment.
: To embroider words exceeding the size of
NOTE
the embroidery hoop, re-hoop your fabric. Use
the
POSITIONING ARROWS
character to the last one in the combination. The
needle indicates the starting position. Also use
the
CHECK SIZE BUTTON
embroidery.
: Characters on the optional font Embroi-
NOTE
dery d-Cards 100:3, Palace Script and 100:4, Kalli-
graphia, are embroidered as above.
to position the next
to outline the size of the