The Functions Panel - Husqvarna Viking Platinum 995E User Manual

The Functions Panel

Stitch Length
When you select a stitch, your Platinum
955E automatically sets the best stitch
length. The set length is visible on the
InfoDisplay above the stitch length
button. You can change the stitch length
by pressing either the (+) or (-) button.
Minimum and maximum settings are indi-
cated with a "beep" signal.
The buttons are also used to set button
size when the Sensor Buttonhole Foot is
connected.
Stitch Width
The stitch width is set by the stitch in the
same way as the stitch length. The set
width is visible on the InfoDisplay above
the stitch width button. The width can be
adjusted between 0 and 6 mm. If straight
stitch is selected, the width button is used
to adjust the needle position (25 needle
positions). Minimum and maximum set-
tings are indicated with a "beep" signal.
Functions and InfoDisplay on your Platinum 955E
Thread Tension
Adjust top thread tension by touching (+)
or (-). The tension indication dial on the
sewing head indicates the ten sion set ting.
The high er the number the more ten sion
on the top thread. The adjustment will be
retained until the machine is turned off.
: Do not try to turn the tension dial manu-
NOTE
ally.
Mirror Side to Side
Touch this button to mirror the selected
stitch side to side. If this button is
touched when straight stitch with adjusted
needle position is selected, the needle
position is changed from left to right. If
touched in rep, the whole stitch combina-
tion is mirrored.
When
MIRROR SIDE TO SIDE
icon is shown on the InfoDisplay.
If you try to mirror a stitch that cannot
be mirrored, Platinum 955E beeps.
is active, an
35