Lower The Feed Teeth; Changing The Presser Foot; Changing The Needle - Husqvarna Viking Sapphire 930 User Manual

Lower the feed teeth

The feed teeth are lowered when you move the switch on the
front of the free arm to the right. Move the switch to the left if
you wish to raise the feed teeth. The feed teeth will raise as you
begin to sew. The feed teeth should be lowered when sewing on
buttons and for free motion sewing.

Changing the presser foot

Press the ON/OFF switch to "O".
1. Make sure the needle is in the highest position and the presser
foot is lifted. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the presser
foot ankle. Push back until the foot snaps into place.

Changing the needle

Press the ON/OFF switch to "O".
1. Use the hole in the multipurpose tool to hold the needle.
2. Loosen the screw in the needle clamp with the screwdriver.
3. Remove the needle.
4. Insert the new needle using the multipurpose tool. With the
will go no further.
5. Use the screwdriver to tighten the screw.
Getting ready to sew
1
13