Lower The Feed Teeth 2:10; Changing The Presser Foot 2:10; Changing The Needle 2:10 - Husqvarna Viking Viking Topaz 40 User Manual

LOWER THE FEED TEETH
The feed teeth are lowered when you move the switch on the
front of the free arm to the right. Move the switch to the left
if you wish to raise the feed teeth. The feed teeth will raise
as you begin to sew. The feed teeth should be lowered when
sewing on buttons and for free motion sewing.
CHANGING THE PRESSER FOOT
1. Make sure the needle is in the highest position and the
presser foot is lifted. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push back until the foot snaps into
place.
CHANGING THE NEEDLE
1. Use the hole in the multipurpose tool to hold the
needle.
2. Loosen the needle screw.
3. Remove the needle.
4. Insert the new needle using the multipurpose tool. Push
the new needle upwards with the flat side away from you
until it will go no further.
5. Tighten the needle screw.
2:10